Tiny Home Site Preparation – What Do You Need Before Delivery?
Delivery & site

Tiny Home Site Preparation – What Do You Need Before Delivery?

Good site preparation makes tiny home delivery much easier. This guide covers access, ground preparation, foundations, drainage, services, truck and crane access, and what should be ready before delivery day.

9 min readDelivery & siteReviewed Sep 2026

The short version.

  • Prepare the site before the cabin arrives

    The final position, foundations or supports, access and service plan should all be worked through before delivery day.

  • Truck access matters as much as the final space

    A cabin may fit perfectly once installed but still be difficult to deliver because of narrow driveways, tight corners, trees, fences or overhead lines.

  • The ground needs to support the installation

    The site may require clearing, levelling, drainage work or an appropriate foundation or support system depending on the cabin and installation.

  • Plan utilities early

    Power, water, wastewater and stormwater should be considered before final positioning so connections can be made efficiently.

Once you've chosen a tiny home, the next question is:

What needs to happen on the property before it arrives?

A transportable home can arrive largely complete, but the site still needs to be ready for it.

That usually means planning:

  • The exact cabin position
  • Vehicle access
  • Ground preparation
  • Foundations or supports
  • Drainage
  • Power
  • Water
  • Wastewater
  • Stormwater
  • Truck or crane access
  • Any required compliance work

Getting these things organised before delivery makes the final installation significantly simpler.

Start by confirming the exact position

Don't prepare a vague area of the property and decide where the cabin will sit when the truck turns up.

The final location should be established beforehand.

Consider:

  • Property boundaries
  • Required setbacks
  • Existing buildings
  • Sun and outlook
  • Privacy
  • Access between the cabin and main home
  • Parking
  • Outdoor living
  • Service locations
  • Delivery access

If you're still deciding where the home can go, start with: Where Can You Put a Tiny Home in NZ?

Once the position is confirmed, the rest of the site-preparation work can be designed around it.

Does the site need to be level?

The final installation needs an appropriate stable base, but that doesn't necessarily mean the entire section needs to be perfectly flat.

What matters is that the chosen foundation or support system can provide a suitable level platform for the home.

Site work could involve:

  • Removing vegetation
  • Excavation
  • Levelling
  • Filling
  • Compacting
  • Retaining work
  • Drainage
  • Preparing foundation locations

A sloping property can often still accommodate a tiny home, but it may require more preparation than a flat site.

This can affect both cost and delivery complexity.

What type of foundation does a tiny home need?

There is no single foundation system used for every tiny home.

The appropriate solution depends on:

  • How the home is constructed
  • Its size and weight
  • Ground conditions
  • Site slope
  • Intended use
  • Applicable building requirements
  • Whether future relocation matters

Depending on the project, the home might use:

  • Piles
  • Engineered supports
  • Concrete foundations
  • Steel supports
  • Another designed base system

The important point is to establish the foundation solution before delivery.

The transport team needs to know exactly where and how the home will be positioned.

Why ground conditions matter

A heavy transport vehicle and a completed home place very different demands on a site from a normal car.

Consider whether the ground is:

  • Soft
  • Wet
  • Recently filled
  • Steep
  • Uneven
  • Prone to flooding
  • Difficult for heavy vehicles to cross

A lawn that looks perfectly fine may not necessarily support a large delivery vehicle after heavy rain.

In some cases, temporary access may need to be created or strengthened.

This is particularly relevant on rural properties, lifestyle blocks and sites where the final cabin location is some distance from the road.

Check access from the road to the final site

One of the most important parts of site preparation is making sure the cabin can actually reach the position you've chosen.

Walk the complete route.

Entrance width

Check gates, fences, pillars and neighbouring obstacles.

Driveway width

Remember that the cabin may be significantly wider than the truck itself.

Corners

Long transport vehicles need much more room to turn than a car.

Overhead clearance

Look for:

  • Power lines
  • Phone lines
  • Trees
  • Branches
  • Carports
  • Eaves

Side clearance

Check:

  • Fences
  • Buildings
  • Retaining walls
  • Hedges
  • Posts

Ground clearance

Steep changes in gradient can create problems for longer vehicles and low parts of the building or trailer.

Don't assume that because a truck can drive down the driveway, the cabin can follow it.

Do fences or trees need to be removed?

Sometimes.

Temporary removal may be required where:

  • A gateway is too narrow
  • A fence prevents the required turning angle
  • Branches reduce height clearance
  • Landscaping blocks the route
  • The truck needs additional manoeuvring room

It is much easier to identify and organise this in advance than to discover it with the delivery vehicle sitting at the entrance.

Where trees need significant work or overhead lines are involved, use the appropriate professional rather than attempting to create clearance on delivery day.

What if the truck can't reach the cabin position?

This is where crane placement may become an option.

A crane can sometimes place a tiny home:

  • Behind an existing house
  • Over a fence
  • Across landscaping
  • Onto a site away from direct vehicle access
  • Into a position the transport vehicle cannot reach

But a crane needs its own suitable setup area.

Planning needs to consider:

  • Cabin weight
  • Lift distance
  • Obstacles
  • Crane location
  • Ground conditions
  • Access for the crane itself

The longer the lift and heavier the home, the larger the equipment may need to be.

Craneage can add substantially to the project cost, so determine whether it is required before buying or confirming delivery.

Think about drainage before the home arrives

Water management around the site is easy to overlook.

Consider:

  • Where surface water naturally flows
  • Whether the site becomes wet in winter
  • Roof-water disposal
  • Ground clearance
  • Whether water can collect underneath or around the home
  • Existing drains
  • The effect of new paths, decks or foundations

The aim is to position and prepare the home so water can be managed appropriately rather than creating a damp or poorly drained area around the building.

Stormwater planning may also form part of the wider building or site requirements for your project.

Plan power before final positioning

Don't wait until the home is sitting in place to ask how electricity will reach it.

Before delivery, establish:

  • Where the existing electricity supply is
  • Where the tiny home connection will be
  • Whether trenching is needed
  • Cable route
  • Switchboard requirements
  • Whether solar or an off-grid solution will be used

If underground services need to be installed, it can make sense to complete relevant groundwork before the cabin arrives and restricts access.

Electrical work should be carried out by appropriately qualified tradespeople.

Plan the water connection

For a self-contained tiny home, you also need to know where the water is coming from.

That may be:

  • Existing mains water
  • A private water supply
  • Rainwater tanks
  • Another suitable source

Consider:

  • Distance to supply
  • Pipe route
  • Tank location
  • Pumps if required
  • Where the connection enters the cabin

Again, knowing the final cabin position makes this much easier.

Wastewater is one of the most important site checks

If the home has:

  • Toilet
  • Shower
  • Basin
  • Kitchen
  • Laundry

you need an appropriate wastewater solution.

That could involve:

  • Council wastewater
  • Existing on-site wastewater
  • Septic system
  • A new treatment system

Check capacity and requirements early.

On rural land in particular, an on-site wastewater system can influence where the tiny home can actually be positioned, because room may be required for treatment and disposal areas.

Wastewater should therefore be part of the site plan — not something added after the cabin has been placed.

What about stormwater?

Roof water from the new building needs somewhere to go.

Depending on the property, stormwater may be managed through:

  • Existing stormwater infrastructure
  • Soakage
  • Tanks
  • Another appropriate system

If you're collecting rainwater for household use, the roof may also form part of the water-supply system.

Your site and applicable council requirements will determine the appropriate approach.

Should services be connected before or after delivery?

Usually there are two parts to this.

Before delivery

Prepare the site-side infrastructure where practical:

  • Trenches
  • Pipes
  • Cable routes
  • Wastewater system
  • Tank location
  • Connection points

After positioning

Make the final connection between the services and the tiny home.

This sequence prevents the cabin itself from getting in the way of groundwork and allows connection points to line up with the actual building.

The exact sequence should be planned with the relevant trades and installation team.

What about steps and decking?

Unless they are integral to the building, steps, decks and outdoor areas are generally easiest to finish after the cabin has been positioned.

But they should still be planned beforehand.

Think about:

  • Finished floor height
  • Main entry
  • Number of steps
  • Deck location
  • Paths
  • Accessibility
  • Outdoor living
  • Drainage

If accessibility is important, the entry arrangement can significantly influence the site layout.

What should happen before delivery day?

Ideally, by the time the truck arrives you already know:

Where the home is going

The exact position and orientation are marked and agreed.

How it will get there

Truck route, turning areas and crane requirements have been confirmed.

What it will sit on

Foundations or supports are completed and ready.

How the site will handle water

Drainage and stormwater have been considered.

How utilities will work

Power, water and wastewater solutions are planned and any relevant groundwork is complete.

What needs to be moved

Fences, trees or temporary obstacles have already been dealt with.

What approvals are required

Any applicable consent, exemption or site requirements have been completed before installation.

Delivery day should be execution of the plan, not the day the plan is created.

Tiny Home Site Preparation Checklist

Before booking the final delivery, check:

Position

  • Final cabin position confirmed
  • Orientation confirmed
  • Site dimensions checked
  • Boundary requirements checked
  • Separation from other buildings checked

Ground and foundations

  • Vegetation cleared
  • Site level/prepared as required
  • Ground conditions assessed
  • Foundations or supports completed
  • Drainage considered

Access

  • Road access checked
  • Gate width checked
  • Driveway width checked
  • Turning room available
  • Overhead clearance checked
  • Trees trimmed if required
  • Fences removed if required
  • Ground capable of handling delivery vehicles

Crane

  • Crane requirement assessed
  • Crane access confirmed
  • Setup area available
  • Lift route clear

Services

  • Power plan confirmed
  • Water supply confirmed
  • Wastewater solution confirmed
  • Stormwater solution confirmed
  • Trenches/connection routes planned

Delivery

  • Transport provider has site information
  • Final measurements confirmed
  • Relevant trades coordinated
  • Weather/ground conditions suitable
  • Site ready before truck arrival

Common mistakes to avoid

Choosing the cabin before checking access

You may discover the home you want is larger than the route onto the property allows.

Preparing only the footprint

The truck and crane may need considerably more room than the finished cabin.

Leaving wastewater until the end

This can affect both site position and total project cost.

Assuming flat-looking ground needs no preparation

Ground stability, drainage and appropriate support still matter.

Forgetting overhead obstacles

Trees and power lines can be more restrictive than driveway width.

Building the deck first

Decks and landscaping can make positioning the cabin harder. Complete the core building placement first.

Site preparation and delivery should be planned together

Site preparation isn't separate from delivery.

The two need to work together.

The home's dimensions and weight influence access and foundations.

The property influences transport and positioning.

The final position influences services.

And the services can influence where the home should go.

That's why it helps to choose a real cabin and plan around its actual dimensions rather than preparing a generic area and hoping the home works later.

Once your property is ready, our guide How Are Tiny Homes Delivered and Installed? explains what happens from transport through to final placement and connection.

Start with the actual cabin

If you're preparing a property for a tiny home, knowing exactly what you're buying makes the process much easier.

You can work from:

  • Actual dimensions
  • Actual weight
  • Connection points
  • Door locations
  • Bedroom layout
  • Final floor height

rather than estimates.

Browse Tiny Homes Available Now to see completed cabins, then plan the site around the specific home you're considering.

Get the site ready before the truck arrivesGood preparation reduces surprises on delivery day.

In real life

Get the site ready before the truck arrives

Once you've chosen the cabin, its actual dimensions, weight and connection points can be used to plan the foundations, access and services properly.

Questions about this topic.

What needs to be done before a tiny home is delivered?

You should confirm the final building position, prepare the ground and foundations or supports, check delivery access, plan power, water and wastewater connections, and identify whether craneage or other specialist equipment is required.

Does the ground need to be level for a tiny home?

The home needs an appropriate level and stable installation, but the entire property does not necessarily need to be flat. Sloping sites may require additional groundwork or a suitable engineered support system.

Do foundations need to be finished before delivery?

Where the installation uses prepared foundations or supports, these should normally be ready before the home arrives so it can be positioned correctly.

How wide does the driveway need to be for tiny-home delivery?

There is no single minimum because it depends on the width and length of the home, transport vehicle, corners and surrounding obstacles. The complete delivery route should be assessed for the specific cabin.

What if the truck can't get to the final position?

A crane may sometimes be able to lift the cabin into place. Feasibility depends on the cabin's weight, lift distance, obstacles, crane access and ground conditions.

Should utilities be installed before the tiny home arrives?

It is often useful to prepare site-side services and underground routes beforehand, then make the final connections after the home is positioned. Coordinate this with the relevant trades and installation team.

Do I need to organise wastewater before delivery?

Yes. If the home is self-contained, the wastewater solution should be established early because it can affect cabin placement, site preparation and total project cost.

Should I build the deck before the tiny home arrives?

Usually it is more practical to position the home first and construct external decks, stairs and finishing work afterwards, unless the specific project requires otherwise.

Can a tiny home be delivered across a lawn or paddock?

Potentially, but ground conditions must support the heavy transport equipment. Wet, soft or steep ground can create significant access problems, so this should be assessed before delivery.

Next step

Ready to start planning your site?

Choose from the cabins currently available, then use the actual home dimensions and specification to plan access, foundations and services.

No pressure · Reply within one business day


Where to go from here.